There are two ways to install WinProxy 3.0 on an existing network. The main difference between these two methods is the utilization of the DHCP feature within WinProxy 3.0.

NOTE You must have a basic network. For this description, we are assuming several things about your local setup. You already have your computers connects with a working Ethernet network, either several networked through a hub, or two back-to-back with a cross over cable. One of the computers has a modem or other internet connection connected to it- this will be one that gets the WinProxy installation. Only one computer will have WinProxy installation. Only one computer will have WinProxy installed. You already have some network protocols installed- probably NetBEUI- and your computers have already have NetBIOS names. The NetBIOS name of each computer can be found at Control Panel => Network => Identification => Computer Name.

About DHCP

---

1. Configuration of the internal network card on the WinProxy computer.
2. Configuration within the WinProxy application.
3. Configuration of the network card on the client computer.
4. Configuration of applications to go through WinProxy.

---

1. Configuration of the internal network card on the WinProxy computer.
2. Configuration within the WinProxy application.
3. Configuration of the network card on the client computer.
4. Configuration of applications to go through WinProxy.